Answer:
65 ml
Explanation:
The aluminum will not float , so it will displace a volume of fluid equal to its volume.
13.5 gm / 2.7 gm/ml = 5 ml
the new graduated cylinder measurement will be 60 + 5 = 65 ml
A catalyst ______. (select all that apply.) multiple select question. is depleted in a chemical reaction undergoes no permanent change during a reaction does not participate in a chemical reaction
The statements that are true regarding a catalyst are as follows:
It undergoes no permanent change during a reaction
It does not participate in a chemical reaction
What is a catalyst?
A catalyst is a substance that increases the rate of a chemical reaction without being consumed in the process.
A catalyst increases the rate at which a chemical reaction occurs by decreasing the activation energy of the reaction.
Since a catalyst is not used up in the reaction, the following statement applies:
It undergoes no permanent change during a reaction
It does not participate in a chemical reaction
Learn more about catalyst at:
#SPJ1
Which would you expect to have the
highest pH (closest to 14)?
Answer:
yes
Explanation:
im pretty sure yes, also i think this is 20 characters long
At constant pressure, the volume of a gas is directly proportional to temperature as measured on the __ temperature scale.
At constant pressure, the volume of a gas is directly proportional to temperature as measured on the kelvin temperature scale.
What is Temperature?This is defined as the degree of hotness or coldness of a substance and is influenced by thermal energy.
The standard unit is Kelvin which also compares it to volume at constant pressure of a given gas.
Read more about Temperature here https://brainly.com/question/2331658
#SPJ1
A sample of cobalt has a mass of 27 g and a density of 9 g/cm^3. What would be its volume?
What property of a substance does its specific heat capacity describe?
OA. How much heat is needed to melt it
OB. How much kinetic energy it contains
O C. How much heat it takes to raise the temperature
D. How good an insulator it is
Answer: How much heat it takes to raise the temperature
Specific heat describes how much heat a substance takes to raise the temperature. Hence, Option (c) is correct
What is Specific Heat ?
Specific heat capacity is the amount of heat energy required to raise the temperature of a substance per unit of mass.
The specific heat capacity of a material is a physical property.
It is also an example of an extensive property since its value is proportional to the size of the system being examined.
Specific heat describes how much heat a substance takes to raise the temperature. Hence, Option (c) is correct
Learn more about Specific heat here ;
https://brainly.com/question/21041726
#SPJ1
Match the following
1. coefficient
2. law of conservation of mass
3. product
4. reactant
the number written in front of a
chemical symbol in an equation
principle that during a chemical
reaction the total mass of the system is
unchanged
the substance made in a chemical
reaction
the starting material in a chemical
reaction
The order would be coefficient, law of conservation of mass, products, and reactants respectively.
Word matchingThe number written in front of a chemical symbol in an equation is called a coefficient.
The total mass of a system being unchanged is known as the law of conservation of mass
The substances made in chemical reactions are called products.
The starting materials in chemical reactions are called reactants.
More on reactions can be found here: https://brainly.com/question/17434463
#SPJ1
HELP ASAP PLEASE
The primary cause of water pollution is:
Answer:
the aNSWRER TOP UR QUESTION IS THAT I NMEED TO ANSWER THIS SO I DONT HAVE TO WQATCH ADS LOL
Explanation:
DSADSDASDASDASDSDSDSDSDS and i knowq chem is bio chwem is
When the temperature of a liquid is increased a little,
what happens to its particles?
Answer:
The particles moves faster thus Expanding the liquid
If someone asked you to mix up a bag of ringers solution with 150 meq/l of na , 10 meq/l of k , 8 meq/l of ca2 , and 197 meq/l of mg2-, how many grams of mg2- would you add to the mixture?
The normality is the ratio of the equivalent to the volume of the solvent. To the mixture, 1.182 gms of magnesium should be added.
What is Normality?Normality (N) is the grams or moles of solute per liter of solution.
Magnesium has 2 valence electrons in the outermost shell so,
1 mEq of Mg⁻² ions = atomic number of Mg ÷ valence electron
= 12 ÷ 2
= 6 mg
In a liter solution having 197 meq/l of Mg⁻²:
197 meq/l of Mg⁻² × 6 = 1182 mg
Therefore, 1.182 gms of magnesium ions should be added to the mixture.
Learn more about gram equivalents here:
https://brainly.com/question/14833835
#SPJ4
During a reaction, the enthalpy of formation of an intermediate is 34 kJ/mol. During the reaction, 4 moles of the intermediate are produced. What is the enthalpy value for this step of the reaction?
The enthalpy change for the formation step of this intermediate is 136 kJ/mol.
What is the enthalpy?The enthalpy of reaction can be obtained from the enthalpies of formation of the species involved. The enthalpy of reaction is the heat evolved or absorbed in a reaction.
Thus, the enthalpy change for the formation step of this intermediate is 4 * 34 kJ/mol = 136 kJ/mol.
Learn more about enthalpy change:https://brainly.com/question/4526346
#SPJ1
Predict the product of the reaction of cyclopentanone with ethylene glycol, p−toluenesulfonic acid, and benzene
The answer to the product of the reaction of cyclopentanone with ethylene glycol, p−toluenesulfonic acid, and benzene is attached in the figure.
What is a reaction ?A chemical process in which substances act mutually on each other and are changed into different substances, or one substance changes into other substances is called a reaction.
Chemical reactions are an integral part of technology, of culture, and indeed of life itself.
The Product obtained of the reaction of cyclopentanone with ethylene glycol, p−toluenesulfonic acid, and benzene is attached in the figure .
To know more about reaction
https://brainly.com/question/17434463
#SPJ4
How many moles of na contain 7.88x1021 atoms of na
Answer:
the answer to the qustion is 0.013089701 na
Explanation:
n/a
Newman projections are given for two of the conformers of 2-methylbutane, drawn as viewed down the C2-C3 bond. In A the _____ strain is at a maximum due to the eclipsing of bonds. In B this strain is minimized but there is still _____ strain due to the proximity of the bulky CH3 groups that are _____ to each other. Multiple choice question.
The Newman projection gives the view of the molecule. In molecule A the torsional strain and in B steric strain are present because of the gauche methyl group.
What is a torsional strain?The Newman projection depicts the molecules in the head-on view and uses the letters and the lines to represent the molecule. The torsional strain is because of the molecule's resistance to the twisting.
The steric strain is the Vander wall strain that is due to the forced interaction of the molecules separated by covalent bonds resulting in molecular potential energy.
The diagram for the question is attached below.
Therefore, the correct blanks are torsional, steric, and gauche.
Learn more about torsional strain here:
https://brainly.com/question/27852131
#SPJ1
Based on the shapes of the water drops in part D, how does the attractive force between water and wax compare to the attractive force between water and glass?
Answer:
Because the cohesive forces inside the droplets are stronger than the adhesive forces between both the drops and the wax, water does not penetrate waxed surfaces. Because the adhesive forces between the liquid and the glass are stronger than the cohesive forces inside the water, water wets glass and spreads out across it.
Explanation:
EDMENTUM
A gas at STP is heated to 35 degrees
C. What is the new pressure of the gas?
A gas at STP is heated to 35 degree C. The new pressure will be 2.41 atm.
What is Gay-Lussac law?The pressure of the mass of the gas is directly proportional; to the temperature of the gas.
[tex]\dfrac{P_1 }{T_1} =\dfrac{P_2}{T_2}[/tex]
Converting the temperature into kelvin
The initial temperature = 35 °C = 35 + 273 K= 308 K
The final temperature = 50 °C =50 + 273 K = 323 K
Initial pressure = 2.3 atm
Final pressure ?
Putting the values in the equation
[tex]\dfrac{P_1 }{T_1} =\dfrac{P_2}{T_2}\\\\\\{P_2 = \dfrac{P_1 \times T_2}{T_1} \\\\\\\\\\{P_2 = \dfrac{2.3 \times 323 }{308} = 2.41 atm.[/tex]
Thus, the new pressure will be 2.41 atm.
Learn more about Gay-Lussac law
https://brainly.com/question/11387781
#SPJ1
You can make a solution (solid solute) more concentrated by
adding more solute
O increasing the pressure
adding more water
adding more solvent
Answer:
increasing the pressure
Explanation:
You can make a solution more concentrated by increasing the pressure.
What causes lines in a line spectrum?
A. Transitions that don't happen to an electron
B. Wavelengths of absorbed or emitted photons
C. Quantum numbers associated with an electron
D. Edges on the prism used to separate wavelengths
Wavelengths of absorbed or emitted photons causes lines in a line spectrum.
What causes lines in a line spectrum?Spectral lines are produced by transitions of electrons within atoms. As the electrons move closer or farther from the nucleus of an atom, energy is released in the form of light is emitted.
So we can conclude that Wavelengths of absorbed or emitted photons causes lines in a line spectrum.
Learn more about spectrum here: https://brainly.com/question/1968356
#SPJ1
Help number 5 question
Answer:
In water, bases dissolve and provide hydroxide (OH-) to the surrounding solution. This lowers the acidity of the solution.
The following diagram represents what type of reaction?
The type of reaction represented by the diagram is (C). Fission
Meaning of Nuclear FissionNuclear fission can be defined as a reaction in which the nucleus of an atom splits or breaks into two or more smaller portions of nuclei.
Nuclear fission is so important and is often seen or encountered when dealing with elements with high nuclear properties.
In conclusion, the type of reaction represented by the diagram is Fission
Learn more about Nuclear Fission: https://brainly.com/question/3992688
#SPJ1
The isotope sodium-24 has a half-life of 15 hours. Starting with 22 grams, how much remains in 45 hours
The amount, in grams, that will remain of the isotope will be 2.75 grams
Half-lifeIt is the time it takes for a given amount of radioactive substance to decay into half of its original amount.
The half-life is 15 hours. This means that the amount is halved every 15 hours.
If the starting amount is 22 grams, it will become 11 grams (22/2) after the first 15 hours. The 11 grams will become 5.5 grams (11/2) after another 15 hours, making 30 hours.
The 55.5 grams remaining will become 2.75 grams (5.5/2) if another 15 hours should pass, making a total of 45 hours that have passed.
Thus, only 2.75 grams of the isotope will remain in 45 hours.
More on half-life can be found here: https://brainly.com/question/24710827
#SPJ3
4- If 10 ml of a 1.5 M H2SO4 solution has been diluted by adding 100 ml of water to the original solution, what is the final concentration of the solution?
The final concentration of a solution that has been diluted by adding 100 ml of water to the original solution is 0.15M.
How to calculate concentration?
The concentration of a solution can be calculated using the following formula:
C1V1 = C2V2
Where;
C1 = initial concentration
C2 = final concentration
V1 = initial volume
V2 = final volume
1.5 × 10 = 100 × C2
15 = 100C2
C2 = 0.15M
Therefore, the final concentration of a solution that has been diluted by adding 100 ml of water to the original solution is 0.15M.
Learn more about concentration at:
#SPJ1
Under what circumstances can the general trend to disorder in the universe be reversed?
Answer:
See explanation.
Explanation:
This will never naturally occur but you can tweak the system quantum mechanically to temporarily reverse entropy.
What is the ph of 0.05l of hand soap? is it acidic or basic?
Match the following items.
1. not affected by a magnet
2. mostly space
3. flows freely but particles still attract
4. positively charged particles
5. free to move in all space
6. negatively charged particles
7. atoms nearly fixed in space
8. helium nucleus
proton
solid
liquid
gamma ray
gas
atoms
electron (beta)
alpha particles
Answer:
1. not affected by a magnet 1 liquid
2. mostly space 2 solid
3. flows freely but particles still attract 3 proton
4. positively charged particles 4 gas
5. free to move in all space 5 alpha particles
6. negatively charged particles 6 atoms
7. atoms nearly fixed in space 7 gamma ray 8. helium nucleus 8 electron (beta)
Moving electrons are found to exhibit properties of.
Answer:
both particles and waves
Explanation:
this is known as wave-particle duality.
I hope this helps.
Have a nice day.
Hello Brainly! Please Help! Thank You! (The Directions are the Red Text)
Answer:
ok so which answer do you want if you want all then here's this
Explanation:
you should remember that you aren't the only on who dosent know the answers because I don't so ask a parent
1kg of hydrogen is burned in oxygen how much energy is released
Answer:
121 million joules energy is released
Explain :
As there are 500 moles of hydrogen gas in a kilogram, this means that burning a kilogram of hydrogen gas releases 500 times as much energy or 121 million joules .
Explain the three ways you can accelerate a golf cart?
Answer:
Pedal, Pushing, and also launching it off a cliff with a catapult
Explanation:
I know nothing
1CO₂ (g) + 1C (s) → 2CO (g)
Keq =
Answer:
the equation is balanced
How many milliliters of a stock solution of 2.50 M SrCl2 would you need to dilute to make 50.0 mL of 1.00 M SrCl2?
Answer:
20 ml
Explanation:
2.5 M x = 1 M * 50
x = 20 ml